Hugo Wifi remote case

Check out github repository:
https://github.com/mcer12/Hugo-ESP8266

There are 3 versions of the top cover. The original I/O one, one with shapes and one clean with no icons for easy remixing, enjoy! And if you like your print, share a photo :)

*EDIT:* Added stl variants that are 0.2mm larger on the sides in case the standard enclosure doesn't fit
*EDIT2:* Added a version with holes for 3 magnets for stronger hold, recommended!
*EDIT3:* Added new cover with dots.

- print without supports
- requires 4 8x1mm neodymium magnets
- requires double sided 3M tape for wall mounting

Print settings for best results (cura):
- line width: 0.5mm
- wall line count: 3
- 100% infill for top+bottom cover, 20% for wall mount
- ideally everything should snap together very tight and there should be no play. Otherwise try to increase extrusion rate by 3-5%