Thingiverse
Hula Whoop gate
door Thump2010
73
Downloads
48
Likes
1
Makes
I made a hula hoop gate, there are 2 versions, one uses the full hoop (small hoop) and the other you cut the hoop in half.
The half hoop feet stack (not tightly but enough to help carry, there is a hole to tie some twine in between the feet to hold their shape in case you don't want to stake them down like if indoors. You can also use the stake holes to attach them to a wall.
The half hoop versions also come with either 2 or 3 feet for stabilization, I thought each foot needed three extensions for stabilization but found 2 worked fine.
The stripes are just colored electrical tape over the hoop.
They are easier to see inside than they are outside.
I used 4 perimeters to make is stronger.
Infill is whatever you want it to be.
Doesn't need support
The half hoop feet stack (not tightly but enough to help carry, there is a hole to tie some twine in between the feet to hold their shape in case you don't want to stake them down like if indoors. You can also use the stake holes to attach them to a wall.
The half hoop versions also come with either 2 or 3 feet for stabilization, I thought each foot needed three extensions for stabilization but found 2 worked fine.
The stripes are just colored electrical tape over the hoop.
They are easier to see inside than they are outside.
I used 4 perimeters to make is stronger.
Infill is whatever you want it to be.
Doesn't need support
Thump2010 publiceert ook op
96 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
