Thingiverse
Hulk - Edge_Lit_Sign
von ZDC
4
Downloads
3
Likes
0
Makes
I cut some on the bottom of the original model just past the coin slot and made approx 155mm fist to fist.
2.5mm thickness for plexi / acrylic piece.
(x9) 3mm LEDs
(x3) LEDs wired in series in 3 groups wired parallel = 9volts
9 volt battery fits in backside using a standard 9v battery connector
Holes on back for mounting
I just glues parts together after wiring.
Use Chalk Board marker to write name, etc on backside of plexi / acrylic for best lighting effect.
2.5mm thickness for plexi / acrylic piece.
(x9) 3mm LEDs
(x3) LEDs wired in series in 3 groups wired parallel = 9volts
9 volt battery fits in backside using a standard 9v battery connector
Holes on back for mounting
I just glues parts together after wiring.
Use Chalk Board marker to write name, etc on backside of plexi / acrylic for best lighting effect.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!