Humidity Meter Holder

I bought one of those Husky Waterproof bins to store my filaments and wanted something to hold the humidity meter by the lid so I can easily see when it's getting too high. That way I can tell when to replace the desiccants. I didn't seal the sides so I can slid the meter out easily if I need to replace the battery.

Fits the Thermpro TP49

The two flat sides are dimensioned perfectly for the command large hanging strips (had to cut a little off the end cause the meter isn't as long as the strips.

V2 has no vent holes for the meter

V3 has the vent holes

No supports needed, I printed with 15% infill