Thingiverse
Hummingbird decoration
door PPTinkles
52
Downloads
39
Likes
1
Makes
A hummingbird suncatcher-type decoration that I based on a clipart image I found somewhere.
Designed using Tinkercad, sliced with KISSlicer, and printed on a PolyPrinter 229.
My settings: 0.25mm extrusion width, 2.5 loops (loop 1 first), 0.75mm skin thickness, 0.25-0.50mm layer thickness, 100% infill for all 4 colors, plus a 2mm diameter 0.25mm brim with the small red pieces
Took a bit of sanding to clean it up and get all the pieces to fit together, but it wasn't too tedious. The pieces were joined using super glue.
A big thank you goes out to the very nice & helpful folks at the Fort Worth Library for being able to use their printers!
Designed using Tinkercad, sliced with KISSlicer, and printed on a PolyPrinter 229.
My settings: 0.25mm extrusion width, 2.5 loops (loop 1 first), 0.75mm skin thickness, 0.25-0.50mm layer thickness, 100% infill for all 4 colors, plus a 2mm diameter 0.25mm brim with the small red pieces
Took a bit of sanding to clean it up and get all the pieces to fit together, but it wasn't too tedious. The pieces were joined using super glue.
A big thank you goes out to the very nice & helpful folks at the Fort Worth Library for being able to use their printers!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
