Thingiverse
Husky ScrewOn Screwdriver cap
door rgayle
1
Downloads
1
Likes
0
Makes
This is a cap for a Husky Screwdriver that has bits in the top. Not sure of the model of the screwdriver, its over 10yrs old.
This was printed using PETG, so a bit of stringing may occur inside the dome area. Since
This was printed using PETG, so a bit of stringing may occur inside the dome area. Since
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!