Thingiverse
HUZZAH ESP8266 Breakout Case
von rickbme
4
Downloads
3
Likes
0
Makes
Needed a small case to hold an Adafruit Huzzah breakout for a wifi enabled Octoprint filament runout sensor.
Print at .2 or even .15 for best results.
100% infill yielded the best results, but 30% works too :)
Included the step file for anyone needing to adjust anything.
Print at .2 or even .15 for best results.
100% infill yielded the best results, but 30% works too :)
Included the step file for anyone needing to adjust anything.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
