Thingiverse
Hydroponic pot
by mafaldo
9
Downloads
8
Likes
0
Makes
I've designed this pot for my Dionea.
Total height 15cm, upper diameter 12cm, lower diameter is 11cm.
The tank height its about 3cm.
You just need to make holes and add the cotton threads.
The next step will be to add a float.
Printed in PLA, 0,2 layer at 20%. Only 1 perimeter.
This print take 20 hour and 20 meter filament (3mm)
Total height 15cm, upper diameter 12cm, lower diameter is 11cm.
The tank height its about 3cm.
You just need to make holes and add the cotton threads.
The next step will be to add a float.
Printed in PLA, 0,2 layer at 20%. Only 1 perimeter.
This print take 20 hour and 20 meter filament (3mm)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
