Thingiverse
Hydroponic PVC Connectors
por techappsgoodson
95
Descargas
56
Likes
0
Makes
These are for 3" standard PVC pipes.
I put GE Silicone #1(https://www.amazon.com/GE-Silicone-Purpose-Caulk-GE012A/dp/B0000CBIH9) inside the edge of the PVC tube and on the inner ring of the print. Squished it together, collected excess, and no leaks or strength problems
I found that anything less than 100 percent infill causes leaks.
***edit*** After experimenting, the 1/2 inch connectors always seemed to not drain enough. Unless you want a trickle system, I'd recommend staying with the standard 3/4 in converter.
I put GE Silicone #1(https://www.amazon.com/GE-Silicone-Purpose-Caulk-GE012A/dp/B0000CBIH9) inside the edge of the PVC tube and on the inner ring of the print. Squished it together, collected excess, and no leaks or strength problems
I found that anything less than 100 percent infill causes leaks.
***edit*** After experimenting, the 1/2 inch connectors always seemed to not drain enough. Unless you want a trickle system, I'd recommend staying with the standard 3/4 in converter.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
