Hygrometer Holder

Adjustable angle hygrometer holder for round hygrometers- will work with all tab patterns. Tired of bending down to get the right viewing angle for you hygrometer? Tilt the hygrometer instead! Open Back design: does not block any sensors and the battery is swappable without removing the stand. Prints in less than 30 minutes. No additional hardware is needed. Fast and easy print- Less than 8.2 grams! If you need an adjustable mount for your rectangular hygrometer, I make one too!https://makerworld.com/en/models/901588#profileId-860704 Installation:Print in place, no supports, no brim (make sure build plate is clean).After printing, rotate the housing in the base. A little bit of force will be needed to loosen the joint.Push the hygrometer into the housing; the tabs will snap in and lock the hygrometer in the housing.NOTE: Level hygrometer before pushing it all the way in.Removal: With hygrometer facing away from you, put index and middle finger nails on both sides of the housing.Point t