Thingiverse
Hygrometer/Temperature Stand
von PKKShadow
2
Downloads
1
Likes
0
Makes
Basic stand/mount for the cheap hygrometer/temperature meters you find on amazon, ebay, alibaba, etc...
In the stl, there is a 0.3mm thin layer in the hole where the meter would go. I did that because of how I printed it face down. Figured it would help with bed adhesion.
As you can see in the pictures, there are holes for stress relief that uses zip ties. (the sanding marks are from me removing the elephant's foot.) You may have to use super glue or some other kind of adhesive to keep the meter in place if you choose to remove the tabs that hold these things in a hole.
The source file is included.
In the stl, there is a 0.3mm thin layer in the hole where the meter would go. I did that because of how I printed it face down. Figured it would help with bed adhesion.
As you can see in the pictures, there are holes for stress relief that uses zip ties. (the sanding marks are from me removing the elephant's foot.) You may have to use super glue or some other kind of adhesive to keep the meter in place if you choose to remove the tabs that hold these things in a hole.
The source file is included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
