Thingiverse
Hyperboloid Pedestal
por kirberich
46
Descargas
37
Likes
0
Makes
A simple pedestal/stand/vase/hat based on a hyperboloid - can be printed completely hollow at large sizes while retaining a lot of strength.
The only tricky bit is the top surface - when printed large, especially if your printer isn't good at bridging, you might want to add a few percent of infill.
The only tricky bit is the top surface - when printed large, especially if your printer isn't good at bridging, you might want to add a few percent of infill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!