Thingiverse
Hypercube 40mm Fan Cover
von 2c2know
48
Downloads
32
Likes
0
Makes
Simple Hypercube fan guard for 40mm fans. Two different models were modelled, also, versions with 1mm and 2mm standoffs were uploaded.
Didn't print it yet but should be fine, anything just leave a comment.
Slower speeds (under 50mm/s) might give better results.
Check more designs here: http://www.thingiverse.com/2c2know/designs
Didn't print it yet but should be fine, anything just leave a comment.
Slower speeds (under 50mm/s) might give better results.
Check more designs here: http://www.thingiverse.com/2c2know/designs
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
