Hypercube 50mm Adjustable Leg

These legs for the 2020 bottom corners on the Hypercube (or any 2020 cube frame) allow you to raise the bottom extrusions off your workbench anywhere between 50-80mm. Each foot is easily adjustable to allow for compensation of uneven worksurfaces. These also allow you to remove the inner 20mm brackets.

Print Recommendations:
I printed these in PETG with 3 perimeters, 6 top/bottom layers, and 20% gyroid infill. I also printed relatively hot so I could get better layer adhesion, so I had to use supports for the nut and screw head slots. All of this was likely overkill on my part, but I do intend for this to be a pretty mobile printer so I wanted something that I knew wasn't gonna give out on me any time soon.

Required Hardware:
8x 10mm M5 bolts and M5 T-Nuts (you should have these lying around from constructing your Hypercube)
4x 30-40mm M8 Hex Bolts with Nuts (or 1-1/2" - 2" 5/16 SAE Hex Bolts, SAE nuts are thicker than M8 nuts so they will be a bit proud, this doesn'