HyperCube Adjustable Z Endstop

Update 18-01-18
I have been asked to explain how the parts fit together.

If you look at the first picture above you will see how the red and blue parts are fitted.
The endstop micro switch is mounted on the endstop mount as shown in the second picture. The M3 nut is inserted in the slot in the back of the endstop mount.
Before fitting the endstop mount insert the M3x70 screw into the Adjustable mount V2 and fit the spring to the screw. Fit the endstop to the Adjustable mount and adjust the height with the M3x70 screw. Attach the assembled parts to the frame with an M5x10 and an M5 drop in hammer nut as shown in the second picture.
The trigger is bolted to the back bed rail with the remaining M5x10 and M5 drop in hammer nut and aligned to trigger the micro-swich as shown in the second picture.

Update 17-12-23
After using the end stop since August I found that the end stop trigger was not sturdy enough and as I started off a print it finally the upright trigger broke off the b