Thingiverse
HyperCube (and Evo) Leg Extension
von superjamie
282
Downloads
161
Likes
0
Makes
This is a foot designed to attach to the bottom of the HyperCube or HyperCube Evolution frame (or any other 2020/2040 or 3030 aluminium extrusion printer) to lift it up, letting you put stuff underneath or attach feet easier.
The picture shows a 2020 leg, an untested 3030 leg STL is provided.
You can use a stick-on foot like 3M BumpOn or generic floor protector, or a rubber surface protector foot with a hole for an M5 screw, or an eBay "vibration dampener" with M5 thread vulcanized into it. If you can print flexibles you could print a foot too.
A nut trap is included to accept an M5 nut to hold a foot screw, or you can use a long screw or threaded rod through to the frame if you lengthen the design.
I wanted to flip the Z motor mount to use a longer Z screw, so I needed to lift the printer up 60mm or so. That's the STL that's included, and the OpenSCAD source is available if you wish to modify it.
The picture shows a 2020 leg, an untested 3030 leg STL is provided.
You can use a stick-on foot like 3M BumpOn or generic floor protector, or a rubber surface protector foot with a hole for an M5 screw, or an eBay "vibration dampener" with M5 thread vulcanized into it. If you can print flexibles you could print a foot too.
A nut trap is included to accept an M5 nut to hold a foot screw, or you can use a long screw or threaded rod through to the frame if you lengthen the design.
I wanted to flip the Z motor mount to use a longer Z screw, so I needed to lift the printer up 60mm or so. That's the STL that's included, and the OpenSCAD source is available if you wish to modify it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
