Hypercube evolution bed leveling knob shorter shaft

I printed a set of the original bed leveling knobs for the HEVO but I found the shaft was too long due to my using strong springs. I remixed it so the bottom half of the shaft was removed. Thank you to the original designer I remixed this from.

As with the original I remixed from M3 nuts are used. They are a tight fit. I used a screw to pull them through and then pushed on them with a hex wrench to make sure secure. I also used M3X50 machine head screws (tapered to fit into my hotbed plate) for extra length (the standard bed leveling screws are 40mm in length).