Hypercube Evolution dual radial fan mount

The original Hypercube Evolution cooling fan shroud was blowing directly on my heating block and performed poorly. I decided to remix the original file and make some improvements. This version puts a BLTouch 18.25mm behind the nozzle on an
adjustable mount to support either the E3D V6 or the Volcano. All heatserts have been removed(!) and have been replaced with trapped nuts. The original fan mount was converted over to a support for the bowden tube and greatly improved print quality. And perhaps most noticeable of all, this mount accepts two radial fans which improved bridging quite a bit.

Print settings:
I used PETG with 25% infill for everything. Supports are needed on the retainer and extruder mount but only from the print bed and not internally.

The fan ducts were designed to not require support and are in the orientation to print them in (flat rectangle near the exhaust hole)

Probe location:
X0 Y18.25

Notes:

This assembly is very compact and is a tight fit.