Thingiverse
Hypercube Evolution Short Bed Bracket
von bkahan
6
Downloads
2
Likes
0
Makes
I cut the wrong 2020 extrusion for my bed on my Hypercube evolution 400x400x400 build.
This works for the MK2S 400x400 3mm heated bed aluminum build plate.
My y axis is approximately 14in / 355mm.
Change the offset parameter in the fusion file for your custom short bracket!
Note: You need a longer screw for the spring bed leveling mount. Also, each bracket requires 3 2020 screws with nuts.
Print in PETG or ABS!
Update 5/20/20:
- Removed the right angle brace as I realised that it is very difficult to use and is not needed structurally.
This works for the MK2S 400x400 3mm heated bed aluminum build plate.
My y axis is approximately 14in / 355mm.
Change the offset parameter in the fusion file for your custom short bracket!
Note: You need a longer screw for the spring bed leveling mount. Also, each bracket requires 3 2020 screws with nuts.
Print in PETG or ABS!
Update 5/20/20:
- Removed the right angle brace as I realised that it is very difficult to use and is not needed structurally.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
