Thingiverse
HyperCube Evolution Y Carriage Clamp
door 0scar
53
Downloads
27
Likes
0
Makes
This Y carriage clamp is inspired on "HyperCube Evolution Igus Carriage Clamp tenser" from Thingiverse user "endeffect" and the original Y carriage clamp from "SCOTT_3D".
The purpose of this clamp is to take the pressure of the bearings when fastening the clamp using the 2 screws that press onto the 8 mm steel X shafts. Brass inserts are used for threads of these screws. As I'm not using steel bearings, but self made long POM bearings using this design: https://www.thingiverse.com/thing:2476782, I need this stress relief clamp to prevent binding when you (over) tighten the 4 mounting screws.
Furthermore, the clamp extends to the overall width of the bearing and includes a ring/ridge to prevent the bearing to slip.
The STL includes integrated supports for the 4 fastener screws, just take a 3 mm drill bit after printing. Please print with the most flat face down.
Note that the cover photo shows the original and the remix of the clamp.
The purpose of this clamp is to take the pressure of the bearings when fastening the clamp using the 2 screws that press onto the 8 mm steel X shafts. Brass inserts are used for threads of these screws. As I'm not using steel bearings, but self made long POM bearings using this design: https://www.thingiverse.com/thing:2476782, I need this stress relief clamp to prevent binding when you (over) tighten the 4 mounting screws.
Furthermore, the clamp extends to the overall width of the bearing and includes a ring/ridge to prevent the bearing to slip.
The STL includes integrated supports for the 4 fastener screws, just take a 3 mm drill bit after printing. Please print with the most flat face down.
Note that the cover photo shows the original and the remix of the clamp.
0scar publiceert ook op
56 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
