Thingiverse
HyperCube improved parts
por EvRU
28
Descargas
11
Likes
0
Makes
Just some parts improved for my setup.
1. Z Shaft Clamp - print 0.2mm, 3 perimeters,100% infill (on the picture it is printed with HIPS)
2. XY Joiner - is for 10mm shaft - printed 0.2mm 50% infill
3. Dual bushing holder improved for printing with HIPS without fan duct.
4. Universal Y shaft clamp, 0.2mm 100% infill
5. XY Motor Left need some support from the surface
6. XY Motor Right need some support from the surface
1. Z Shaft Clamp - print 0.2mm, 3 perimeters,100% infill (on the picture it is printed with HIPS)
2. XY Joiner - is for 10mm shaft - printed 0.2mm 50% infill
3. Dual bushing holder improved for printing with HIPS without fan duct.
4. Universal Y shaft clamp, 0.2mm 100% infill
5. XY Motor Left need some support from the surface
6. XY Motor Right need some support from the surface
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
