Hypercube Rear Drive Stepper Conversion

These parts will convert the corexy of a hypercube to allow it to be driven from the rear, keeping the front clear of belts and motors.

I have this currently installed and is working, some tweeks may be made in the future.

**Parts Required** (# if reusing parts from original mounts):

M3 x 50mm Bolt - 2 off. (2) *For stepper idler bearing.*
M3 x 8 or 10mm Bolt - 8 off. (0) *For stepper motor fixation*
M3 x 22mm Bolt - 2 off. (2) *For front idlers*
M3 x 35mm Bolt - 2 off. (2) *For rear idlers*
M3 washers - 10 off. (10) *For stepper fixation & idler bearing*
M3 Nylock Nut - 4 off. (2) *For frame idler bearings*
M3 Nut - 2 off. (2) *For stepper idler bolt*

GT2 16T Smooth Idler Bearing (or 4x original bearings) - 2 off. (2) *For stepper idler.*
GT2 16T Idler Bearing - 2 off. (2) *For rear idlers.*
GT2 20T Idler Bearing - 2 off. (2) *For front idlers*
New GT2 6mm Belt - Your original belt length will be too short.

**Please Note:**

This conversion requires