Thingiverse
HyperCube Z Brackets
von Jdevil
18
Downloads
7
Likes
0
Makes
Based on design of #Makerbiors
This is my version of Hypercube Z Clamps for 8mm Shafts as well as Bed Brackets for LM8UU bearings. Brackets give more Z travel (more than 200mm) and before the X Carriage would hit the Z brackets on max Y travel.
Z travel increased and allows bed to sink below rear extrusion brace. ZShaftTop Printed 2x. Requires M4x10 and M3-20 to mount.
This is my version of Hypercube Z Clamps for 8mm Shafts as well as Bed Brackets for LM8UU bearings. Brackets give more Z travel (more than 200mm) and before the X Carriage would hit the Z brackets on max Y travel.
Z travel increased and allows bed to sink below rear extrusion brace. ZShaftTop Printed 2x. Requires M4x10 and M3-20 to mount.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
