Thingiverse
Hyperlite Floss 3 Parts
von PadMack
15
Downloads
7
Likes
0
Makes
Few parts for the Hyperlite Floss 3 Drone
1. This is a Fin with a mount built in for a Foxeer Lillipop Antenna.
2. This is a Fin with a mount built in for an SMA Antenna Connection.
3. 45° Camera Mount for a micro sized camera. Designed around a Caddx Ratel but should fit any other 19mm camera.
4. Arm / Motor Protector. Motor in the photo is a 2306.
All designed to be printed in TPU
1. This is a Fin with a mount built in for a Foxeer Lillipop Antenna.
2. This is a Fin with a mount built in for an SMA Antenna Connection.
3. 45° Camera Mount for a micro sized camera. Designed around a Caddx Ratel but should fit any other 19mm camera.
4. Arm / Motor Protector. Motor in the photo is a 2306.
All designed to be printed in TPU
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
