Hyperlite FlosStyle SMA Mount

This is an interim update without the receiver tube holders.. I tested my version over the weekend just gone and it places the receiver antennas in the same plane as the vtx antenna so it wasn't an ideal setup.

This is still a nice sma holder for the frame!

SMA mount for the rear of the Hyperlite Flosstyle frame.

SMA holder has a recess to hold the 8mm fixed hex section of the pigtail. When printed this hex section will appear like its too tight to fit but once you thread the nut on and tighten, the nut will pull the base into the recess (assuming you're printing at 100% and 100% extrusion rate). Just don't go crazy with the torque - ones you've pulled the base into the recess, thats as far as it needs to go, you'll just squish and weaken the tpu if you go further.

Don't be afraid to let me know what you really think about the design.