Thingiverse
Hypnotic Battlebot
by Posey
8
Downloads
3
Likes
0
Makes
1lb. Plastic Antweight robot, competed at multiple competitions and placed 1st & 2nd
Printing/Assembly Info:
-Print everything at 100% Infill
-Set wall perimeters to 6, top/Bottom at 3
-Weighs 427g
Electronics Needed:
-4 N20 Motors
-1 Dual Motor Controller
-1 Reciever
-1 Switch
-1 3S Lipo Battery
-2 Wire harnesses for parallel motors
Other Materials Needed:
-4 40mm Wheels(Pololu)
-5 M3x5mm screws
-4 Zip ties
-4 M3x30 screws
-4 M3 Nuts(Not needed, but can be used in case holes are stripped on bot)
Printing/Assembly Info:
-Print everything at 100% Infill
-Set wall perimeters to 6, top/Bottom at 3
-Weighs 427g
Electronics Needed:
-4 N20 Motors
-1 Dual Motor Controller
-1 Reciever
-1 Switch
-1 3S Lipo Battery
-2 Wire harnesses for parallel motors
Other Materials Needed:
-4 40mm Wheels(Pololu)
-5 M3x5mm screws
-4 Zip ties
-4 M3x30 screws
-4 M3 Nuts(Not needed, but can be used in case holes are stripped on bot)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
