Hypnotoad theremin using VL53L1X laser sensor

My remix adds a VL53L1X laser sensor to brooksben11's "Motion-Triggered Hypnotoad with Sound"...
https://www.thingiverse.com/thing:3944899

( Note: I did not change anything to this thing other than scale it up to 150% of the original size in my slicer, Cura. )

I added the laser sensor mount to srbecerrita's "Hypnorock for Hypnotoad"...
https://www.thingiverse.com/thing:3755555

using Thomx Ju's "VL53L0X Screwable Case"...
https://www.thingiverse.com/thing:3763978

The VL53L1X I used fits this case perfectly but I did enlarge the opening for the sensor slightly.
( Note: in the photo, I left the sensor cover temporarily unpainted to make it easier to see )
To protect the wiring that runs to the sensor I made a bottom plate that can be glued to the bottom of the rock.

Rather than use brooksben11's motion sensor electronics I instead set up the laser sensor to act as a Raspberry Pi theremin using rbnrpi's writeup at...
https://rbnrpi.wordpress.com/new-sonic-pi-theremin-u