Hyundai Window Regulator Bracket

This is a bracket that is part of the window regulator assembly of a Hyundai Veracruz.It probably fits other models as well. The factory part is too thin and the cables pull out causing the window to fall into the door. This one is designed to be much stronger.

Print it with 100% fill in a higher temperature material like ABS. Orient the cable grooves vertically to get the best strength on the slide clip on the opposite side. It will require support for the coble socket, but I recommend blocking the supports inside the slot thru the middle that the sheet metal tab goes thru. It is a bit of a pain to remove it and it's unnecessary. Dipping the part in acetone briefly will strengthen it as well.

If this part is broken it is likely that the winch cables are frayed and bent up. You will need to replace them as well. I tested two cables. The first was the correct diameter obtained from a bicycle shop. That type of cable is too stiff however and I found it was rubbing on the inside o