i3 Mega Angled Hotend Cover V2

This hotend cover is a remix of my previous hotend cover for the Anycubic i3 Mega / Mega S. The new cover includes a cooler-looking vent design and a removeable front cover that allows you to print normally or access wiring without undoing any screws. You could alternatively just leave the cover off if you like that look. The cover locks into place and the holes at the top sit over the screw heads. Simply pull the cover out from the bottom and lift over the screws to remove.

Supports are needed only for the front, which has a 70 degree overhang. You could alternatively print it upright but I haven't tried that yet. This cover can be used with any fan duct designed to fit the original stock metal cover, such as my own design (remix) here: https://www.thingiverse.com/thing:4796829