i3 Mega S Spool Holder Upgrade
von voirottto
12
Downloads
2
Likes
0
Makes
Advanced upgraded spool holder for i3 Mega S.
This is an advanced upgrade to reduce friction for the Spool and than reduce the stress on the extrusor.
What do you need:
4x m4 bolt and nut (length 15 or 20 mm)
4x bearing size: 4mm internal hole, 12 or 13 mm external diameter, 4 or 5 mm height
Instructions:
1) print it
2) screw the bolt as in the third photo
3) screw the bolts in the holes as in the second picture
4) put it on the original spool holder. Optionally it can be glued with double-sided adhesive tape.
This is an advanced upgrade to reduce friction for the Spool and than reduce the stress on the extrusor.
What do you need:
4x m4 bolt and nut (length 15 or 20 mm)
4x bearing size: 4mm internal hole, 12 or 13 mm external diameter, 4 or 5 mm height
Instructions:
1) print it
2) screw the bolt as in the third photo
3) screw the bolts in the holes as in the second picture
4) put it on the original spool holder. Optionally it can be glued with double-sided adhesive tape.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
