Thingiverse
Iambic Key Paddle V2
von Hadgee
40
Downloads
17
Likes
0
Makes
Hi,
My v1 of 3D printed key. I needed one for a Arduino project I was working on so quickly designed and printed this one. (Archived)
It feels ok and works but will make some slight changes to v2.
Version 2:
Newly added V2 Paddle lighter action and wire routing recess points and a couple of tweaks.
I haven't printed new Top and Bottom but knew tweaks were required.
My v1 of 3D printed key. I needed one for a Arduino project I was working on so quickly designed and printed this one. (Archived)
It feels ok and works but will make some slight changes to v2.
Version 2:
Newly added V2 Paddle lighter action and wire routing recess points and a couple of tweaks.
I haven't printed new Top and Bottom but knew tweaks were required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!