Slicer Discord
Icom 705 Backpack – 3D-Druckmodell von Thingiverse Thingiverse

Icom 705 Backpack

von GI1MIC
28 Downloads
10 Likes
0 Makes
Zum Modell
** This is a work in progress **

I could not justify the cost of the ICOM LC-192 for my IC-705 radio. So instead I decided to adapt a low cost (£23) “sling” camera bag.

A sling bag is one that can be carried on your back or swung round onto the tummy. A special side flap allows access to the bag without removing it.

The bag I selected is a generic one measuring 26.5*15.3*44 cm (10.3" x 6.0" x 17.35"). In the UK it is available from Amazon and goes under the names of “CADEN Camera Sling Bag” or “BAIGIO Camera Sling Backpack Waterproof Camera Case”. It the US you can find it by searching Amazon for “Camera Sling Backpack Camera Waterproof”

Oher than physical size the important point to verify before purchase is that the selected case has Velcro over the bulk of its interior surface. Some of the lower cost bags only have a couple of strips to hold the interior dividers in specific locations.

With the case in hand attaching the 705 to the interior is accomplished with a s
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen