ID-5100 Display Stand Remixed

I liked the design by by badtime of a Stand for the Icom ID5100 with the angled display.
(https://www.thingiverse.com/thing:1788573) but it was hard to impossible to print.
Also, the two legs weren't the same size.
So I duplicated one of the legs and replaced the worst one.
I felt the legs might not be strong enough so I added a bit of extra support.
Then I cut the surround away so the the main part can be printed flat and the surround printed separately.

I also added some pin guides to the surround to mate with holes in the main part to assist easy assembly.