MakerWorld
Organizers
Ver Modelo
ID Card case
46
Descargas
22
Likes
26
Makes
A case for the ID card. The part to take out the card, must be put into the case after printing.When inserting the card, you should place the card under the small component. Once that's done, all you have to do at the end is press it a little and the card is solid in place.For an even printing result, I set the Max volumetric speed for the Translucent PETG from 6mm/s to 4 mm/s.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
