ID Card Holder

Here is an ID card holder for cards of size approximately 85x54mm and 0.75mm thick. The holder has minimal card bordering allowing the card content to be fully displayed. The ID card can be instantly installed or removed from the holder, too; especially convenient for cards that need to be often removed, inserted or otherwise.The holder is intended for portrait card display. The lanyard clip hole can take clips up to 4mm in diameter.My print is made in 1.75mm eSUN PLA Plus Orange filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer. Print supports are not required.I hope you can find this print useful, too.Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.