ID Card Holder

ID card holder designed to be printed flat in two pieces that can then be clipped together. This resolves printing issues and strength concerns that I had with most other single piece ID holder models I found that have to be printed upright. This design was made to fit two cards as I am planning to use it for an ID badge and a separate RFID key card. Assembly notes:To join pieces, I would advise starting by clipping the bottom together and then proceed to clip the sides together. Glue is not required, but can be used for added security between the two halves. If using glue, choose an option that has some flexibility when cured because this print itself relatively flexible. Glues that dry quite rigid (e.g., superglue) will likely just crack and not provide much benefit.