![[idbox] Lead Nut Block – Modelo 3D imprimible de Thingiverse](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F5d%2F80%2Ffa%2F90%2F9d%2Fabcb704adf0a5ae80f8d7d2173af45e6_display_large.JPG&w=800&h=800)
Thingiverse
[idbox] Lead Nut Block
por mrm64
0
Descargas
1
Likes
0
Makes
This block is available on DeAgostini idbox.
You can replace a worn brass nut to a new plastic nut.
##Requirements
- 1 x M6 plastic hex nut
- Material: nylon/RENY/POM
- Width across flats: 10mm
- Thickness: 5mm
- Thread pitch: 1mm
- 4 x M3x10mm set screws
- PVAc glue
- Double-sided adhesive tape (Include peeling layer)
- Threadlocker
##Inspired From
- [idbox LEAD NUT CASE by ichibey](https://www.thingiverse.com/thing:2142060)
##Print Settings
- Filament material: PLA
- Nozzle diameter: 0.4mm
- Layer height: 0.2mm
- Density: 100%
- Supports: no
You can replace a worn brass nut to a new plastic nut.
##Requirements
- 1 x M6 plastic hex nut
- Material: nylon/RENY/POM
- Width across flats: 10mm
- Thickness: 5mm
- Thread pitch: 1mm
- 4 x M3x10mm set screws
- PVAc glue
- Double-sided adhesive tape (Include peeling layer)
- Threadlocker
##Inspired From
- [idbox LEAD NUT CASE by ichibey](https://www.thingiverse.com/thing:2142060)
##Print Settings
- Filament material: PLA
- Nozzle diameter: 0.4mm
- Layer height: 0.2mm
- Density: 100%
- Supports: no
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
![[idbox] Anti Wobble Clamp](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2F8a%2Fa3%2Ff2%2F59%2Fc4%2F96e33d89ca26f5585dfca5e8073ecaff_display_large.JPG&w=400&h=300)
