Ideaspark ESP32 with OLED Case

I created a case for my Ideaspark ESP32 with OLED project.
The board fits snug in the case. The lid is friction fit, it fit nicely for me.
It has the pins exposed underneath so you can use jumper leads, I did not make a closed version.
There two versions of the lid, one with and without custom switch holes for my use, I included so if someone else wanted to do the same.
My project has two switches, they are 3x6x5mm tactile switches, soldered between GND+D12 and D32+D34, they are soldered directly to the top of the pins. 1mm from the side of the board. The holes for the switches are customised for that only.
I did not make holes for the built in switches, during the whole programming process, they were never pressed, so I never used them.
I think you could fit a Lithium Battery in the cavity under the board, there is a battery connecter under the board but I do not think it has a charging circuit so I am not sure if it is useful without it, plus the battery connector faces the side of