Thingiverse
IEC Mount (snap-in)
door ScottieD369
28
Downloads
24
Likes
0
Makes
AC Power IEC Standard C-14 Inlet Connector Snap-In R-301SN
This design is like all my other type of snap-in's.
They have to be recessed with a thin low tight fit with a border.
Outside of the border you can have your thicker normal walls.
Check out my older other one
Just a square. Because you can screw it in with hardware.
https://www.thingiverse.com/thing:4999545
Check out the 120VAC Outlet Holder
https://www.thingiverse.com/thing:4992409
This design is like all my other type of snap-in's.
They have to be recessed with a thin low tight fit with a border.
Outside of the border you can have your thicker normal walls.
Check out my older other one
Just a square. Because you can screw it in with hardware.
https://www.thingiverse.com/thing:4999545
Check out the 120VAC Outlet Holder
https://www.thingiverse.com/thing:4992409
ScottieD369 publiceert ook op
48 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!