MakerWorld
Hand Tools
Go to Model
iFixit Multi Bit Offset Screwdriver (4mm)
425
Downloads
121
Likes
324
Makes
A quick 30 minute print offset wrench for the ifixit toolkit bits or other 4mm bit sets. Useful for tight spaces that need hand torque. It was designed with using the short end, but put a 4mm slot on both ends. If you have the ifixit set it can fit inside the case loose. Image contains the measurements. 25mm x 85mm & 10mm thick at its widest point. Prints with no support with standard PLA.IMPORTANT: First time use it you'll want to prime the hole with a bit first. You WILL want to have pliers on hand but it should fit better after pressing the bit in and removing it a couple times. Profile uses a .1 mm layer height since the tolerance levels are so low for the 4mm bits.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
