iFlight iX3 - VTX Pigtail Mount

This piece provides a 20 degree back-angled mounting hole to screw on an SMA pigtail pushed up from below. As a bonus, it also provides a rear-facing flat-edge where I attached my LED strip and buzzer.

Designed this part to press-fit over the vertical support struts on a iFlight iX2 Lite V3

This frame:
https://smile.amazon.com/gp/product/B07H96PQWQ

Although the frame looks like it has a mounting hole on the top bracket, that is too small for SMA.

May require a soft mallet and block of wood to press in place, depending on your print settings and tolerances.


[Edit 7/6/2019]: I added an .stl for a new version with channels for antennas, set apart at 33 degrees. Previously I was just poking them through the frame top and didn't have a great spot for them. Now they have shielded channels to protect from motor strikes and a little stack you can use to shrinktube the antennas in place. Won't work with all antennas so I'm only including it as an additional model.