iFlight XL5 Front Extension

I made this front extension to move my FPV camera forward (and my VTX can now sit just behind the camera which makes cable management easier). The bottom and top sections get bolted to the frame and they also screw into each other near with some blind holes in the bottom section. This should fit any standard FPV camera with roughly 19.5mm spacing. The camera mounting holes are fairly far back to protect the camera as much as possible while not losing any FOV.

This should be printed in PETG with as many perimeters/infill as you feel comfortable. I think I used something along the lines of 6 perimiters with 35% infill. It's survived at least a couple brushes with some branches.