Ikea Alex Door Stop

I have an Ikea Alex Storage Unit that I have my PC in. Since I'm not using the shelf, the door would close too far into the unit, colliding with my pc. This is a simple print that keeps the door flush with the unit when closed. My print settings:- P1S- 0.4 nozzle- 0.2mm layer height- 2 walls- No support needed Warning: when I installed this and then tried pulling it out, the two stems broke off, not in the peg holes thankfully. My next one did not break when I pulled it out but I put this as a warning that it is possible that the stems may break off in the peg holes.