IKEA Alex Drawer Gridfinity Spacer

This is a simple low-filament 20mm Gridfinity spacer for an IKEA Alex drawer to keep your baseplates from sliding around. I printed a bunch of Gridfinity baseplates but the spacer included was slightly too large for my drawer and didn't fit, so I made this instead. MediumMeasurements: 236mm x 20mm x 4mmFilament Usage: ~5.7g Small (x2)Measurements: 146mm x 20mm x 4mm each - 292mm wide side-by-sideFilament Usage: ~3.5g each, ~7g total I made the Medium variant 236mm wide so that it can fit easily on my P1S bed and print multiple on the same plate if needed. Although it's not quite as wide as the Alex drawers, it works perfectly fine for my use case and saves on filament.I also published a Small variant that can be printed on an A1 mini - just print two copies and place them side-by-side in your drawer. NOTE: Please don't assume that the 20mm depth will be perfect for you! While it worked perfectly for me, the IKEA Alex drawer sets are known for manufacturing inconsistencies t