IKEA Aptitlig Shelf Mod

This is a simple shelf mod for the IKEA Aptitlig 24x15cm bamboo cutting board. I had a set of two sitting around that never ended up being used in the kitchen, so I designed these frames for them to convert them into a small bathroom shelf. The connection between the frames and the cutting boards is a simple press fit, assembly should be straightforward. The design fit in the attached project should be okay for the given print settings, but if it's too tight, the bamboo boards sand very easily with some 80 grit sandpaper so you can take off another .5mm if needed. The shelf is designed for 2.5mm nails as mounting hardware; if you need to use bigger nails or screws, you will have to modify the 3D somewhat.