Ikea Blind brackets. Shorter length.

I needed slightly shorter brackets to clear a door frame and also get the blind closer to the glass to shut out more light.
Designed these in Tinkercad, aiming to be a little stronger than originals.

Re-use the slide in clip / lock (that finger that locks the end in place !)

I printed in Floreon PLA (strong PLA) and they worked really well.

Print in orientation as they would be if fitted to a wall (f that makes sense!).
Use full supports (I used 18% zigzag supports in Cura 2.6)
100% infill for strength, might take 2 to 3 hours to print but will be strong.

Holes are 3.5mm slots, Use a flat head screw (not counter sunk type - these can split the layers)