IKEA BROR shelf

I needed some place to put my filament drier whilst also being close to my A1 since I keep it on while printing TPU or translucent PETG to keep the filament dry (after it's been properly dried).I have both my X1C and A1 side by side on my IKEA BROR rack so there just wasn't enough space for the dryer as well. I didn't want to have an unreasonably long PETF tube going from one of the lower shelves. The shelf clips on to the side rail (right side) and enables you to lock it with one of the screws and nuts that came with the IKEA BROR unit. The load is distributed from the plate down through the supports that in turn rests on the IKEA BROR's vertical rail.Holds the dryer and 1 kg of filament with ease. The shelf is printed with just a small amount of support and a couple of brim ears.