Ikea Desk Lamp

Designed for this cord set:
https://www.ikea.com/us/en/catalog/products/40427562/

The thin walls are .5mm thick, so it needs to be printed with a .25mm layer height so when the printer makes two passes it equals .5mm so there won't be any infill in those areas so the light shines through clean. I used white PLA and it has a really nice glow with a warm white LED bulb.

It does requires supports in the cord hole and under where the socket connects to. You could probably get away with not using them in the cord hole if you have faith in your printer's bridging abilities.

This was designed to fit the cord through the side hole completely intact, no need to take apart and rewire the lamp to run the wire through. Although, I accidentally bought the Ikea cord with no switch, so I can't 100% confirm the switch will fit though the hole just yet.