Thingiverse
Ikea Dinning Table Support Clip
von joeypwc
0
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4573d4VJRRz
I made this to replace all the broken original pieces. The hole is a bit smaller than original, but it still fit in with a bit of force, so I did not further fine tune it further. Enjoy!
I made this to replace all the broken original pieces. The hole is a bit smaller than original, but it still fit in with a bit of force, so I did not further fine tune it further. Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!