Ikea Extended Plinth Clip

This is a 45mm extended version of the Ikea plinth clips. Photo shows the original on the left and the new one on the right.
http://www.ikea.com/gb/en/catalog/products/40205599/

I needed these to clear some larger bases required for washing machine / fridge. The Ikea system puts the plinth in quite far from the outer edge.

Its printed horizontally with only a few supports in key locations. The initial print was vertical however layer adhesion was an issue so was not strong enough.

IMPORTANT, add a small brim maybe 3 outlines, this stops the bottom of the rear plate slipping away, see slicer photos. You could add more supports for a cleaner print but I wasn't really worried about its appearance these clips are hidden anyway.